Going the extra mile

  • Shipment on new orders for all Gemini amplifiers is currently January 2019, PowAbeam antennas 3-4 weeks from order.

1:1 Isolation Balun 1-31MHz 5kW

 

  • 1:1 Isolation Balun
  • 1-31MHz
  • 5kW power handling
  • INsertion loss <0.2dB
  • Dual Silver Plated SO239 connectors
 

Availability: In stock

Price excl VAT: £79.95 Incl VAT: £95.94
 
OR

1:1 balun 1-31MHz 5kW model 1116du

The DX Shop are distributors for Balun Designs

 The material utilized for the cores is optimized for the lower HF bands and provides exceptional choking impedance at these frequencies.  Over 5000 ohms of choking on 160m and over 6300 ohms on 80 and 40 meters.  The 1116du even generates over 4000 ohms of choking impedance on 20 meters.  No other design can provide this level of isolation and choking at these lower frequencies.

Testing shows SWR remains below 1.05 across the entire HF band, transformation is perfectly flat, return loss is between 60-80 dbmw and choking impedance is maximized at over 6k ohms on the low HF frequencies. 

Design features:

 

  • Custom mix toroids from Fair-Rite Products allows broad frequency coverage while maximizing performance on the lower Amateur bands. Toroids have a special coating applied for all weather protection and added durability.
  • This Isolation balun has significantly higher common-mode impedance and larger effective core area than other similar designs. It is much more effective than types with ferrite beads, ferrite bars or air wound coax.
  • Windings are Mil Spec 50 ohm coax rated 19kW @ 1MHz and 9kW @ 10 Mhz. Silver flashed braid and center conductor. Solid Teflon dielectric.
  • Typical insertion loss is less than 0.2 dB
  • Power handling of 5kW continuous - 10kW intermittent up to 31 MHz. 
  • SO-239 connectors are silver plated with teflon insulation.
  • All hardware is stainless steel. 
  • Very high efficiency. Will not heat up or saturate like many of the typical "feedline choke" baluns.
  • Balun is built installed in weatherproof 4" X 4" X 2" Nema Box which makes an excellent outdoor weatherproof enclosure.

  

One Exception!!!

It must be pointed out that a 1:1 balun should never be used on the second harmonic of a half-wave center-fed dipole fed with coax (like an 80 meter dipole being used on 40 meters). The impedance can be as great as 10,000 ohms creating very high voltages which can bring about voltage breakdown and/or excessive heating. This exception ONLY applies to HALF WAVE CENTER FED DIPOLES WHEN USING A 1:1 BALUN AT THE FEEDPOINT.